Dell DR4100 Upgrade
Been struggling to upgrade Dr4100.Started yesterday with GUI upgrade which failed. tried to upgrade from cli, failed even with multiple reboots. Tried again today with gui in maintenance mode and still...
View Article2- TL2000 unit, 2 - SAS Card. How do we combine this to one server using BE2012
We currently have 2 units of TL2000. Each TL2000 is install on a different server. We would like to connect both of this unit into one server so we can speed up the process and centralize it. Is...
View ArticleAssistance in setting up iSCSI in MD3200i
I have a existing MD3200i disk storage and the iSCSI is not functioning properly. Currently we are using it and has backup data and we do not want to lose it while iSCSI setup. Please help. Thanks.
View ArticlePowerEdge T410 LT0-3-060 Internal Tape Drive
I'm having trouble with Backup Exec not recognizing the hardware (IBM ULTR SCSI). Backup Exec showed the IBM as busy, however, could not resolve so I removed it from the device pool. Now, backup Exec...
View ArticleChanging MD3000 Manager Host
We have a PowerVault MD3000 in our production environment connected to two servers (one is the management server, the other is just a client that can access and use it). The SAS card that the MD3000...
View ArticlePowervault 124t Post Fail Type(30)
Hi,When I reboot my library 124t, I get the erreor message bellow. Can someone tell me what those this error meanPOST FailType (30)POC:00055POH:00000:00:10 #012Thank you
View Articleequallogic ps6100
Dear All,I have facing undermentioned error on storage box.Critical hardware component failure, as shown next. C2F power module has insufficient hold time. any needful advice to resolve the said...
View ArticleRapid CIFS on Client Server
Hi,Can i check if the Rapid CIFS plugin can be installed on a Hyper-V Windows Core Server (without GUI) to do a client backup to the DR6000?Appreciate the advice. Thanks.Regards,Jamie.
View ArticleConnect TL2000 with LTO6 6gb/s SAS drives to a 13G server that only supports...
I would like to know if we support this kind of configuration ?and whick cables are needed ? Tks for oyur help
View ArticleMD3000 - degraded physical disk channel error
Hi folks,I've inherited responsibility for an MD3000. I'm not very familiar with it, it's the first PowerVault I've dealt with. I noticed an orange light on it, so started digging through MDSM. In the...
View ArticlePowerEdge 2900 Direct Attached Storage Array
I have inherited and repurposed as an FTP server, a PowerEdge 2900 with Windows 2003 Server.It originally had 6x 73Gig SAS drives installed.0 & 1 were mirrored as the C: drive.2, 3, 4 & 5 were...
View ArticleAdding 10Gbe Nic to DR4100
We have a DR4100 with the factory installed 4*1Gb nics. We have added a 2 port 10Gbe nic, but I cannot find any instructions on how to configure it. I would like to the 10Gbe to be the primary...
View ArticleMD3600f - Setup Documentation?
I have a PowerEdge MD3600f, that was purchased by another group. I believe the SA gave up attempting to configure and it's been sitting in a box, for a year or more. I'd like to take advantage of it,...
View ArticleTL4000 Service Password for out of warrenty.
How do I get the service password for an out of warranty TL4000?Basicly I bought it on the used market dirt cheap but its spiting out this error:"HE: sled position not found, unable to locate magazine...
View ArticleDisk drives for PowerVault MD
Hello,I read "Dell™ PowerVault™ MD Series Support Matrix" pdf:11 Supported physical disk drivesNote: Only the physical disk drives with a Dell part number listed in Table 12 aresupported.Table 12...
View ArticleAdding drives to a MD1420
I'm trying to add drives to a MD1420. Dell has indicated that while I can obtain the drives, the caddies (Part # 8FKXC) are no longer available. The suggested replacement part appeared to fit I...
View ArticlePowerVault 114T + R720
I have a PE R720 with a PoweVault 114T which is connected to the server via a LSI Logic 20320IE SCSI card. I am running Windows Server 2012 R2 (64bit). I cannot find drivers for the LSI card...
View ArticleTL4000 ERROR HE: internal SCSI cmd timeout Code: FD 02
Hi,Pls help me I have one Tl4000 Library showing below error.HE: internal SCSI cmd timeoutCode: FD 02. What can I do for this Pls replay ASAP???RegardsGS
View ArticleMD3000i controller troubles (continued)
Hi,This question is related to the following thread:en.community.dell.com/support-forums/storage/f/1216/p/19640747/20791659/I purchased a replacement controller and replaced the controller in slot 0...
View Articlemodular disk storage manager - SMTP port
Is there any way to specify and SMTP port to configure email alerts in the Modular Disk Storage Manager? We have an internal open relay, but we prefer not to use the default port 25 and instead use a...
View Article